Bespoke & shaped rooflights in Edmonton: what is involved?
Our bespoke & shaped rooflights service in Edmonton covers triangular, angled, curved and multi-pane rooflights made to measure. Every job starts with a survey of the opening, the roof covering and the room below, and a fixed written price.
Party walls are a fact of life in London terraces, and rooflights close to a shared wall need detailing that keeps the neighbour's side dry too. In Edmonton, as anywhere, bespoke & shaped rooflights are the usual choice for angled ceilings, corners and architect-designed extensions.
Edmonton sits about 3 km from Tottenham and 3 km from Enfield, and we cover the whole N18 postcode district and the roads in between.
Specification options
- Solar-control and low-iron glass
- Multi-pane butt-jointed runs
- Triangular and trapezoid panes
- Concealed or slim frames
- Sloped or monopitch rooflights
- Corner, slope and multi-pane runs
- Works with architects and builders
Things we check at survey
- Longer lead times and no returns on made-to-measure glass
- Precise survey and template may be needed
Planning, building control and Edmonton
In England a rooflight on a house is usually permitted development under Class C if it projects no more than 150 mm beyond the roof slope and sits no higher than the ridge. Listed buildings need listed building consent, flats have no householder permitted development rights, and an Article 4 direction can remove the rights in some conservation areas.
Building Regulations Approved Document L sets a limiting U-value of 2.2 W/m²K for new or replacement rooflights in existing homes, measured in the horizontal plane; roof windows need 1.4 W/m²K or a Band B energy rating. In an extension, glazing including rooflights is normally limited to 25% of the new floor area plus any windows or doors the extension covers, unless a whole-house calculation shows otherwise.
Our planning guide covers each nation in more detail.
Guide prices for Edmonton
These are typical supply-and-fit ranges. For an address in Edmonton, scaffold, a hoist for heavy glass, or a new structural opening can move the figure, which is why we survey first.
| Option | Guide price inc VAT | Ex VAT |
|---|---|---|
| Multi-pane or corner run | £9,595 – £17,995 | £7,995 – £14,995 |
| Single shaped pane, large Typical | £5,395 – £9,595 | £4,495 – £7,995 |
| Single shaped pane, small | £4,195 – £5,395 | £3,495 – £4,495 |
From enquiry to finished job
- Send the details. Postcode, rough size and a photo of the roof and room.
- Free site visit. For new installs we survey free, measure and confirm the roof detail.
- Agree the quote. You approve the specification and price before anything is ordered.
- Fitting and handover. We install, clean down and leave product and warranty documents.
Bespoke & shaped rooflights near Edmonton
More we do in Edmonton
Common questions
Will a shaped rooflight leak more?
Not if detailed properly — corners and junctions just need more care.
Do you need my architect's drawings?
They help. We still survey on site, because built openings rarely match drawings exactly.
Can I cancel a bespoke order?
Made-to-measure goods are excluded from the statutory 14-day cancellation right. As a goodwill gesture you can cancel without charge until we place the order with the manufacturer, and we tell you in writing when that happens.
Is the survey in Edmonton free?
Yes for new installations. Repair visits are charged, and we tell you the price before we book.
Do you offer bespoke & shaped rooflights in Edmonton?
Yes. We carry out bespoke & shaped rooflights in Edmonton and across Greater London. Send your postcode and we will offer a survey date when we reply.
